单晶硅晶格间距的测量技术进展及应用

单晶硅晶格间距是许多重要物理常数测量的基础。本文介绍了硅晶格间距测量技术的发展历程,包括X射线干涉仪直接测量和晶格比较仪间接测量两种方法,以及影响测量结果不确定度的关键因素。得益于晶格间距测量的进展,在纳米尺度,硅晶格间距被国际计量局(BIPM)批准成为新的米定义复现形式。最后介绍了硅晶格在计量学中的应用,以及基于硅晶格实现纳米几何量测量的溯源体系的研究趋势。     

Existence and asymptotic properties of solutions for a nonlinear Schrödinger elliptic equation from geophysical fluid flows

In this paper, we study the existence and asymptotic behavior of radial solutions for a class of nonlinear Schrödinger elliptic equations on infinite domains describing the gyre of geophysical fluid flows. The existence theorem and asymptotic properties of radial positive solutions are established by using a new renormalization technique.     

平行平板横向剪切干涉仪装调误差的矫正方法研究

对平行平板双光路横向剪切干涉仪的装调进行了研究,提出了一种矫正两个平行平板之间角度误差的方法.输出激光的波前采用Zernike多项式拟合,经过理论推导,发现两个方向差分波前求解出的倾斜像散之差与平行平板的角度误差存在线性关系,利用两个方向倾斜像散之差来矫正两个平行平板之间的角度误差.在平行平板横向剪切干涉仪的装调过程中使两个方向差分波前的倾斜像散之差为零即可以使两个方向的平行平板之间的角度误差值为零.进一步地从实验上证明了这个线性关系,对于所用的实验系统,当离焦像差为-3.224 7±0.001 8,两个方向差分波前的倾斜像散之差波动范围为±2.0×10^-3时,平行平板的角度误差可以控制在8.82″之内,高阶像差对平行平板的角度误差调节精度的影响约为1.63″.该方法具有装调简单、精确度高,易于流程化操作的优点.     

Experimental study on the added mass and damping of a disk submerged in a partially fluid-filled tank with small radial confinement

The dynamic response of submerged and confined disk-like structures is of interest in engineering applications, such as in hydraulic turbine runners. This response is difficult to be estimated with accuracy due to the strong influence of the boundary conditions. Small radial gaps as well as short axial distances to rigid surfaces greatly modify the dynamic response because of the added mass and damping effects.In this paper, the influence of the axial nearby rigid distance on the dynamic response of a submerged disk is evaluated when the radial gap is very small. Moreover, the effects of the fluid depth and fluid viscosity on the natural frequencies and damping ratio of the submerged disk are studied. The study has been performed experimentally and numerically using structural–acoustic simulations.For the experimental investigation a test rig has been developed. It consists of a disk attached to a shaft and confined with a small radial gap inside a cylindrical container full of water. The disk can be moved up and down along the shaft to vary the axial distance to the nearby rigid surface. Piezoelectric patches are used to excite the disk and the response is measured with submersible accelerometers. Several excitation patterns can be used due to the disposition of these piezoelectric patches. For each configuration tested, the dynamic response of the structure is studied analyzing the natural frequencies and damping ratio of the disk attached to the shaft. The numerical results have been compared with the experimental results.     

基于光纤智能夹层传感结构的应力测量研究

制作了一种模块化的光纤传感夹层,对夹层内的光纤传感器的应力特性进行了实验研究。分析了应变对传感系数的影响,对埋入到光纤智能夹层中的两种光纤传感器的输出特性进行了比较。实验结果表明:光纤Bragg光栅传感器的波长漂移与应变之间具有理想的线性关系,但应变灵敏度由1.2pm/με降至1.15pm/με;由于制作工艺的局限,对于非本征F-P光纤传感器,当应变达到350με后,应变与载荷具有较好的线性响应。与非本征F-P光纤传感器相比,光纤Bragg光栅传感器是光纤智能夹层首选的应变传感器。将埋入了Bragg光栅传感器的智能夹层粘贴于某型飞机的翼-身连接构件内部进行监测,实验结果为光纤智能夹层应用于复合材料结构的应变监测提供了参考。     

光纤传输速度干涉仪

介绍一种用多模光纤传输入射和反射激光的速度干涉仪，阐述了这种干涉仪的原理和结构，并将其与传统的速度干涉仪进行比较。给出了用这种干涉仪测量电爆管的弹丸速度和钨样品在铁飞片冲击压缩下的自由面速度的实验装置和结果。文中最后总结了这种干涉仪的性能及特点。     

基于光纤锥级联结构的湿度传感器

提出了一种基于普通单模光纤粗锥级联结构的马赫-曾德尔干涉湿度传感器.将两根单模光纤对芯熔融成一个粗锥,并依次级联,形成光纤锥-单模光纤-光纤锥-单模光纤-光纤锥结构.外界环境湿度、温度的改变使传感器的纤芯基模和包层模的光程差发生改变,引起传感器干涉光谱发生变化.通过监测干涉谱波长和能量的变化实现对外界物理量的测量.实验结果表明,当空气中湿度在35~95%RH范围内变化时,传感器的湿度灵敏度为-0.065dB/%RH,线性度为0.997;当温度在30~80℃范围内变化时传感器的温度灵敏度为69.4pm/℃,线性度为0.998.该传感器可以避免温湿度的交叉影响,实现单参量的同时在线区分测量.     

Polarization phase-shifting interferometer by rotating azo-polymer film with photo-induced optical anisotropy

A new type of phase-shifting interferometer was presented by rotating an azo-polymer film with photo-induced optical anisotropy in the light path of orthogonal polarization interferometry. By changing the angle of the optical axis of the azo-polymer film, four phase-shifted fringe patterns were obtained, from which phase difference between orthogonal polarized light could be calculated. The polarization states and the formation of the interferograms were analyzed theoretically using Jones matrix calculations and the experimental verification of the proposed method was also given. This method has a simple optical configuration which utilizes commercially available polarization devices and anisotropic azo-polymer film of low cost. The phase-shifting interferometer also demonstrates a new application of azo-polymer film.     

In-plane ESPI using an achromatic interferometer with low-coherence laser source

The use of an achromatic interferometer is explored as a means of doing in-plane ESPI measurements using a laser diode as the light source. This interferometer type, which uses a diffraction grating in place of the conventional beamsplitter, has two features that make it suitable for making ESPI measurements over extended areas, even when using a low-coherence laser diode source. First, the parallelogram optical geometry of the interferometer causes all rays passing through to have the same optical path lengths. Second, the interferometer is achromatic, whereby the piezo-actuated mirror that steps the illumination light does so by the same phase angle, independent of wavelength. This latter feature accommodates the spectral impurity of a laser diode source. A periodic variation of fringe visibility is observed in experiments, where narrow ranges of high visibility occur at regular spatial intervals. This behavior derives from the clustered discrete spectral character of laser diode light output. A method to “tune” the interferometer by slightly rotating the diffraction grating is described so as to achieve consistent high fringe visibility throughout the measured images.     

纤维树脂界面剪切强度及纤维强度分布参数的实验测定

界面剪切强度及纤维强度分布参数是复合材料设计及应用研究中的重要参数，本文采用单纤维段埋入法测定了上述两个参数。通过实验研究说明了单纤维段埋入法是一种测定界面剪切强度及纤维强度分布参数的有效的实验方法；同时证实了基体的力学性能对界面剪切强度有着重要的影响。全部实验在自制的实验系统上完成